Section 13 (Manual Transmission - TREMEC 6-Speed (M13 MJK Mm6 MH3) - Diagnostic Information And Procedures)
WARNING: This page is about a different variant/trim than selected.
- Diagnostic Information and Procedures
- DTC P0502 or P0503
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0712 or P0713
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0729 or P0731-P0735
- DTC P0801, P088C, or P088D
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0803, P080C, or P080D
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0806-P0808
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P080A
- DTC P08A8-P08AA
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P08AC
- DTC P18C4-P18C7
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P18C9
- DTC P18CA
- DTC P17A2 (LT1, LT4)
- DTC P17A2 (LTG, LGX)
- Rev Match Switch Malfunction
- Symptoms - Manual Transmission (MJK, MH3, or MM6)
- Symptoms - Manual Transmission (M13)
- Transmission Shifts Hard (MJK, MH3, or MM6)
- Transmission Shifts Hard (M13)
- Transmission Gear Clash When Shifting Gears
- Transmission Noisy (MJK, MH3, or MM6)
- Transmission Noisy (M13)
- Transmission Jumps Out of Gear
- Transmission Does Not Shift into One Gear
- Transmission Locked in One Gear
- Transmission Clunk on Acceleration or Deceleration
- Transmission Fluid Leak Diagnosis
- DTC P0502 or P0503