Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P08A8
- Verify DTC P0807, P0808 is not set.
- Verify there are no DTCs set related to the following component/system:
- B26 Crankshaft Position Sensor
- B115 Vehicle Speed Sensor/B14A Transmission Output Shaft Speed Sensor
- Current Gear = Valid - Calculated
- Engine Torque = Greater than a predefined threshold
- Ignition = On
- Vehicle Speed = Greater than a predefined threshold
Frequency the DTC runs = Continuously - After the running conditions are met
P08A9, P08AA
- Ignition = On
Frequency the DTC runs = Continuously - After the running conditions are met