Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTCs related to the following system/component = Not Set - If equipped
- B14A Transmission Output Shaft Speed Sensor/B115 Vehicle Speed Sensor
- B25B Clutch Pedal Position Sensor
- B26 Crankshaft Position Sensor
- B34 Engine Coolant Temperature Sensor
- B75 Mass Air Flow Sensor
- Q6 Camshaft Position Actuator Solenoid Valve
- Q38 Throttle Body
- Clutch Pedal = Released
- Engine Coolant Temperature = Warmer than 0°C (32°F)
- Engine Speed = Greater than 1, 200 RPM
- Engine Torque = Greater than a predefined threshold
- Transmission Gear = Neutral
- Vehicle Speed = Greater than 20 km/h (12 MPH)
Frequency the DTC runs = Continuously - After the running conditions are met