LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2024 >> Camaro SS, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Manual Transmission - TREMEC 6-Speed (M13 MJK Mm6 MH3) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P18C4-P18C7 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different variant/trim than selected.
Circuit Description
5 V Reference Regulated voltage supplied by the control module.
Signal 1 - Terminal 2@B227 Gear Position Sensor The control module input circuit has an internal resistance connected to 5 V.The sensor produces a PWM signal.
Signal 2 - Terminal 3@B227 Gear Position Sensor The control module input circuit has an internal resistance connected to 5 V.The sensor produces a PWM signal.
Low Reference Grounded through the control module.
Component Description
B227 Gear Position Sensor The sensor contains a hall-effect sensor and additional electronics. It detects the strength of the magnetic field caused by a magnet that is mounted on the shift shaft in the transmission.
K20 Engine Control Module The control module contains a microprocessor used to process input data to control outputs.The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly.
scientia non olet · About LEMON Manuals