Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
| Circuit |
Description |
| Signal |
The control module input circuit has an internal resistance connected to 7.7 V. |
| Ground |
Chassis Ground |
| Component |
Description |
| K9 Body Control Module |
The control module contains a microprocessor used to process input data to control outputs. |
| S147L Manual Transmission Shift Anticipate Switch - Left |
The switch S2L has an internal resistor ladder network. A specific resistance is generated dependent on the position of the switch. |
| S147R Manual Transmission Shift Anticipate Switch - Right |
The switch S2R has three terminals. The switch has a resistor between the input terminal and the internal switch. When pressed or released the switch changes between two output terminals. |