Installing the coolant line between the coolant pump and cylinder head
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the sealing rings (1)
and (2)
on the coolant line (3)
.
Parts: Sealing ring
NOTE: TECHNICAL INFORMATION
Vehicles built before 01/19: The sealing rings of the coolant line cannot be replaced individually.
Replace the entire coolant line. - Vehicles built before 01/19: Replace the coolant line.
Parts: Coolant line
NOTE: TECHNICAL INFORMATION
When assembling, it is essential to observe screwing sequences and tightening torques.
Failure to comply with the regulations can lead to leaks and damage. - Feed in and install coolant line (3) .
- Tighten down screws (2)
.TIGHTENING TORQUE SPECIFICATIONS
Coolant line to coolant pump/cylinder head M6x20 Tightening torque 8 Nm - Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Coolant line to coolant pump/cylinder head | ||
| M6x20 | Tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING ALTERNATOR .
- Refer to INSTALLING THE RIGHT CHARGE AIR DUCT BETWEEN THE EXHAUST TURBOCHARGER AND THE CHARGE AIR COOLER .
- Refer to INSTALLING THE DRIVE BELT FOR THE ALTERNATOR .
- Refer to IF INSTALLED: INSTALLING THE RIGHT BRAKE AIR DUCT .
- Refer to INSTALLING THE WASHER FLUID RESERVOIR IN THE MOUNT .
- Refer to INSTALLING THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to PARTIALLY INSTALLING THE FRONT WHEEL ARCH COVER .
- Refer to INSTALLING THE FRONT RIGHT WHEEL .
- Refer to CONNECTING COOLANT LINE .
- Refer to INSTALLING THE SERVOMOTOR FOR THE ECCENTRIC SHAFT .
- Refer to INSTALLING THE INTAKE PLENUM .
- Refer to INSTALLING THE TANK VENT VALVE .
- Refer to INSTALLING FAN COWL WITH ELECTRIC FAN .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to PREPARING FOR THE INSTALLATION OF THE CLEAN AIR PIPE .
- Refer to INSTALLING CLEAN AIR PIPE .
- Refer to INSTALLING THE REAR BULKHEAD .
- Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to FILLING THE COOLANT CIRCUIT WITH THE VACUUM FILLING EQUIPMENT .
- Refer to CONNECTING THE BATTERY EARTH LEAD .
- Refer to AIR BLEEDING THE COOLANT CIRCUIT .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .