Install clean air pipe
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in clean air pipe (1) and position.
- Secure clamps (3).
- Connect and lock connector (2).
The connector (2) must engage audibly.
- Feed in clean air pipe (2) and install.
The clamp (1) must engage audibly.
- Tighten down screw (3).
TIGHTENING TORQUE SPECIFICATIONS
| Clean air pipe to cylinder head cover | ||
|---|---|---|
| TS6x20 | tightening torque | 8 Nm |
- Connect engine ventilation line (1) on clean air pipe and lock.
Engine ventilation line (1) must engage audibly.
- Connect engine ventilation line (2) to the cylinder head cover and lock.
Engine ventilation line (2) must engage audibly.
Follow-up work
- Refer to INSTALLING THE REAR BULKHEAD .
- Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .