Installing intake silencer housing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the intake silencer housing (5) into the rubber mounts and install it.
Intake filter housing (5) must engage audibly.
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Intake silencer housing to lock bridge | ||
|---|---|---|
| M6X30 | tightening torque | 8 Nm |
- Tighten clamp (4).
TIGHTENING TORQUE SPECIFICATIONS
| Clean air pipe to intake silencer housing | ||
|---|---|---|
| cl. | tightening torque | 3 Nm |
- Connect and lock the connector (3).
The connector (3) must engage audibly.
- Insert and install the holder (1).
Follow-up work