Section 18 (Air Conditioning (Heating, Ventilation And Air Conditioning) (Coupe))
WARNING: This page is about a different variant/trim than selected.
- 87 Air Conditioning
- Component Location Overview - A/C System
- Refrigerant Circuit
- System Overview - Refrigerant Circuit
- Overview - Refrigerant Lines
- Overview - Condenser
- Overview - Heat EXCHANGER For Heat Pump Operation
- Overview - High-Voltage Battery Heat EXCHANGER
- Heater Core Heat EXCHANGER, Removing And Installing
- Refrigerant Receiver, Removing And Installing
- High-Voltage Battery Heat EXCHANGER, Removing And Installing
- High Pressure Sensor -G65-, REMOVING AND INSTALLING
- A/C Pressure/Temperature Sensor -G395-, REMOVING AND INSTALLING
- A/C Pressure/Temperature Sensor 2 -G826-, REMOVING AND INSTALLING
- Refrigerant Lines, Disconnecting And Connecting
- Refrigerant Shut-Off Valve -V424-, REMOVING AND INSTALLING
- Refrigerant Lines With Inner Heat EXCHANGER, Removing And Installing
- Refrigerant Lines In Plenum Chamber, Removing And Installing
- Refrigerant Lines In Plenum Chamber, Removing And Installing, Vehicles Without High-Voltage System
- Refrigerant Lines In Plenum Chamber, Removing And Installing, Q5 With High-Voltage System
- Notes
- Remove the refrigerant line from the Refrigerant Shut-Off Valve -V424- with a branch to the Refrigerant Expansion Valve 2 -N637- to the refrigerant line with inner heat exchanger
- Remove the refrigerant line from the Refrigerant Shut-Off Valve -V424- to the expansion valve
- Remove the refrigerant line from the refrigerant line with inner heat exchanger to the Refrigerant Expansion Valve 1 -N636-
- Remove the refrigerant line from the high-voltage battery heat exchanger to the expansion valve 2
- Refrigerant Line in Engine Compartment, Removing from HighVoltage Battery Heat Exchanger
- Expansion Valve, Removing And Installing
- Refrigerant Lines, Removing And Installing From Expansion Valve
- Condenser, Removing And Installing
- Check Valves In Refrigerant Circuit, Removing And Installing
- Check Valve In Refrigerant Line With Inner Heat EXCHANGER, Removing And Installing
- Check Valve In Refrigerant Line From Refrigerant Receiver, Removing And Installing
- Check Valve In Refrigerant Line From Condenser, Removing And Installing
- Check Valve In Check Valve Refrigerant Line, Removing And Installing
- Refrigerant Lines, Disconnecting And Connecting From Condenser
- Desiccant Bag/Dryer Cartridge, Removing And Installing
- Evacuating And Charging Valve, Removing And Installing, Low And High Pressure Side
- A/C System, Starting After Charging Refrigerant Circuit
- A/C System Refrigerant Circuit, Cleaning, Vehicles With High-Voltage System
- Refrigerant Circuit, Cleaning (Flushing) Information
- Required Tools For Flushing Refrigerant Circuit
- Preliminary Work For Flushing Refrigerant Circuit
- Refrigerant Circuit, Cleaning (Routine "1")
- Refrigerant Circuit, Cleaning (Routine "2")
- Refrigerant Circuit, Cleaning (Routine "3")
- Refrigerant Circuit, Cleaning (Routine "4")
- Heat Pump Valve Unit
- A/C Compressor
- Overview - A/C Compressor
- Overview - Belt Pulley
- OVERVIEW - A/C COMPRESSOR BELT PULLEY, "Denso" VERSION "1"
- OVERVIEW - A/C COMPRESSOR BELT PULLEY, "Denso" VERSION "2"
- OVERVIEW - A/C COMPRESSOR BELT PULLEY WITH A/C Clutch -N25-, "Denso"
- OVERVIEW - BELT PULLEY, "Sanden" A/C COMPRESSOR
- OVERVIEW - A/C COMPRESSOR BELT PULLEY WITH A/C Clutch -N25-, "Sanden"
- A/C Compressor, Removing And Installing From Bracket
- A/C Compressor, Removing And Installing On Bracket, Vehicles With 4-Cylinder Engine
- A/C Compressor, Removing And Installing At Bracket, Vehicles With 6-Cylinder Engine (Except 6-Cylinder 2.9L TFSI Engine)
- A/C Compressor, Removing And Installing At Bracket, Vehicles With 6-Cylinder 2.9L TFSI Engine
- Electrically-Driven A/C Compressor, Removing And Installing On Bracket