Glasses, Window Control Diagnosis - 911 CARRERA (996)

• Introduction
  • Notes
  • General instructions / safety instructions
  • General information on the fault memory
    • Fault code setting conditions
    • Fault memory Info key F8
• Tools
  • Notes
  • Porsche System Tester 2 (PST 2)
  • Commercially available digital multimeter
• Component arrangement
• Connector assignment
  • Connector assignment, control module for Targa roof
    • Notes
    • Plug A
    • Plug B
    • Plug C
    • Plug D
• Control module function
  • Control module replacement
  • Replacing the closing aid
• Fault overview
• Fault code 1
  • Targa roof button, Signal implausible
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/troubleshooting
• Fault code 2
  • Targa flap button, Signal implausible
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/troubleshooting
• Fault code 3
  • Hall signal, Open circuit
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/troubleshooting
• Fault code 4
  • Hall supply voltage, Short to ground
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/troubleshooting
• Fault code 6
  • Targa roof micro switch, Signal implausible
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/troubleshooting
• Fault code 8
  • Closing aid micro switch unlocked, Signal implausible
    • Diagnostic conditions
    • Possible cause of fault
    • Status of the closing aid micro switches
    • Affected terminals
  • Diagnosis/troubleshooting
• Fault code 9
  • Closing aid micro switch pre-notch, Signal implausible
    • Diagnostic conditions
    • Possible cause of fault
    • Status of the closing aid micro switches
    • Affected terminals
  • Diagnosis/troubleshooting
• Fault code 10
  • Closing aid micro switch locked, Signal implausible
    • Diagnostic conditions
    • Possible cause of fault
    • Status of the closing aid micro switches
    • Affected terminals
  • Diagnosis/troubleshooting
• Fault code 12
  • Closing aid motor blocked
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/troubleshooting
• Fault code 14
  • Supply voltage > 15 V or < 9 V
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/troubleshooting
• Fault code 16
  • Sun blind button, Signal implausible
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/troubleshooting
• Fault code 17
  • Fault at the sun blind motor output
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/troubleshooting