Fault code 2: Diagnosis/troubleshooting

DIAGNOSIS/TROUBLESHOOTING FOR FAULT CODE 2

Work instruction			Display OK	If not OK
1	Check switch for Targa rear lid	Switch off ignition Pull off plug at the Targa rear lid switch Measure resistance between pin 1 and pin 2 on the Targa rear lid switch	Switch not actuated Switch actuated < 5 Step 2	Step 3
2	Check leads between the Targa rear lid switch and the control module for short circuit to ground	Pull plug A off the control module Measure resistance between plug on the Targa rear lid switch pin 1 and ground	-> End	Repair wiring harness -> End
	Replace switch for Targa rear window		-> End