Combination Meter - (With Diagnostics)
- General Information
- Service Specifications
- Special Tools
- Diagnosis
- Standard Flow Of Diagnostic Troubleshooting
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B1200: Malfunction of odometer
- DTC B1201: Abnormal fuel information
- DTC B1201: Abnormal fuel information
- DTC B1209: Test mode
- DTC B2203: VIN not programmed
- DTC B2463: Sticking of rheostat switch
- DTC B2464: The sticking of meter information switch
- DTC B2465: Ignition switch signal error
- DTC U0019: Bus off (CAN-B)
- DTC U0100: Engine control module CAN timeout
- DTC U0141: ETACS CAN timeout
- DTC U0164: A/C/Heater control unit CAN timeout
- DTC U0168: KOS-ECU or WCM CAN timeout
- DTC U1000: OSS-ECU CAN timeout
- DTC U1415: Coding not completed/Data fail
- Trouble Symptom Chart
- Notes
- Symptom Procedures
- Inspection Procedure 1: Power supply circuit check
- Inspection Procedure 2: The speedometer does not work (the other meters work)
- Inspection Procedure 3: The tachometer does not work (the other meters work)
- Inspection Procedure 4: Tone alarm does not sound normally
- Inspection Procedure 5: The combination meter light does not illuminate normally or the multi information display is not displayed normally
- Inspection Procedure 6: The multi information display screen cannot be changed with the operation of the meter information switch
- Inspection Procedure 7: Fuel Gauge does not work (other meters work)
- Inspection Procedure 8: Seat belt reminder function does not work normally
- Service Data
- Actuator Test Table
- Check Procedure For Each Multi Information Display Screen
- Check At Ecu Terminals
- On-Vehicle Service
- Combination Meter
- Inspection