Technical Description (Comment)

When the following signals are received via the CAN communication, the combination meter sounds the incorporated tone alarm according to the each pattern.

Keyless operation key reminder tone alarm function (vehicles with KOS)

Ignition switch OFF signal
IG knob push switch ON signal
Driver's door switch ON signal

Ignition key reminder tone alarm function (vehicles without KOS)

Ignition switch OFF signal
Key reminder switch OFF signal
Driver's door switch ON signal

Light reminder tone alarm function

Ignition switch OFF signal
Lighting switch ON signal
Driver's door switch ON signal

Door-ajar warning tone alarm function

Ignition switch ON signal
Any door switch or liftgate switch ON signal
Vehicle speed signal

Freeze warning tone alarm

Ignition switch ON signal
Ambient temperature signal

Multi information display interrupt display tone alarm

Display condition signal of information display from each warning (When there is a fixed tone alarm sounding pattern for each warning, that pattern has the priority.)

Meter information switch operation tone alarm

ON signal for combination meter information switch

Turn-signal light tone alarm function

Turn-signal light switch ON signal

Paddle shift cancel tone alarm, Theft-alarm function, ETACS-ECU function customize tone alarm- A/C operation tone alarm

Sounding request signal from the ETACS-ECU

FCM collision warning tone alarm/FCM approaching warning tone alarm

Sounding request signal from the FCM/LDW/AHB-ECU

LDW warning tone alarm

Sounding request signal from the FCM/LDW/AHB-ECU

BSW tone alarm

Sounding request signal from the BSW-ECU

RCTA tone alarm

Sounding request signal from the BSW-ECU

If the tone alarm does not sound normally, the connector(s) and wiring harness in the CAN bus lines, or the combination meter may have a problem.