Section 7 (Automatic Transaxle Overhaul (F5A5A))

WARNING: This page is about a different variant/trim than selected.

General Description
Special Tools
Transaxle
- Disassembly And Assembly
- Adjustment Of Transaxle
  - Thrust Washer Selection For Adjustment Of Input Shaft End Play
    - <Measurement using a Solder>
    - <Measurement using Plastigage>
  - Spacer Selection For Adjustment Of Differential Case Preload
    - <Measurement using a Solder>
    - <Measurement using Plastigage>
Oil Pump
- Disassembly And Assembly
  - Notes
  - Assembly Service Points
    - >>A<< Oil Seal Installation
    - >>B<< O-Ring Installation
UNDERDRIVE Clutch And Input Shaft
- Disassembly And Assembly
Reverse And Overdrive Clutch
- Disassembly And Assembly
Direct Clutch
- Disassembly And Assembly
Planetary Gear
- Disassembly And Assembly
  - Notes
  - Assembly Service Points
    - >>A<< Thrust Bearing Number 3 And Thrust Bearing Number 4 Installation
    - >>B<< One-Way Clutch Installation
Low-Reverse Brake
- Disassembly And Assembly
  - Notes
  - Assembly Service Point
    - >>A<< D-Ring Installation
Second Brake
- Disassembly And Assembly
  - Notes
  - Assembly Service Point
    - >>A<< D-Ring Installation
Direct Planetary Carrier
- Disassembly And Assembly
Differential
- Disassembly And Assembly
Valve Body
- Disassembly And Assembly
Reduction Brake Piston
- Disassembly And Assembly
Drive Shaft Oil Seal
- Disassembly And Assembly
  - Notes
  - Assembly Service Points
    - >>A<< Oil Seal Installation
    - >>B<< Oil Seal Installation
Specifications