>>D<< Pressure Plate/Clutch Plate/Clutch Disc/Clutch Reaction Plate Installation

CAUTION: Immerse the clutch disc in transmission fluid before assembling it. If the clutch disc is new, soak it in transmission fluid for more than two hours.

1. Install the pressure plate in the direction shown
2. Assemble the clutch discs and clutch plates, one on top of the other, inside the reverse clutch piston. Assemble both clutch plates so that the places with no teeth (marked "A") are aligned with the holes in the retainer (marked "B").
3. Install the clutch reaction plate in the direction shown.

Fig 1: Installing Pressure Plate

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Aligning Clutch Plates Teeth Marked A With Marked B

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.