>>E<< Snap Ring Installation
WARNING: This page is about a different variant/trim than selected.
- Install the snap ring into the groove in the reverse clutch piston.
- Set special tools MB991629 and MD998924 as shown in the illustration, and compress the clutch element.
- Check that the clearance between the snap ring and the clutch reaction plate is within the standard value. If not within the standard value, select a snap ring to achieve the standard value clearance.
Standard value:
1.6 - 1.8 mm (0.0630 - 0.0709 inch)
(For reverse clutch end play)