LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Eclipse Spyder GS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transaxle Overhaul (F5A5A)) >> Direct Planetary Carrier >> Disassembly And Assembly >> Assembly Service Points >> >>D<< Lock Nut Installation

>>D<< Lock Nut Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply ATF on a new locknut, and use special tool MD998834 to tighten the specified torque. Then turn back on turn, and tighten to the specified torque.

    Tightening torque: 170 ± 10 N.m (125 ± 7 ft-lb) 

    Fig 1: Tightening Nut Use Special Tool MD998834
    G06245920Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Use a punch to stake the lock nut at two places.
Fig 2: Staking Lock Nut
G06245921Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals