Electrical System Equipment & Instructions - Testing & Repair - 210 Chassis
- Testing & Repair
- Testing and repair work: Passenger cars: Electrical system, equipment and instruments - AR54.00-Z-9210AA
- Initial filling of battery - AR54.10-P-0001Z
- Disconnect/connect battery's ground cable - AR54.10-P-0003A
- Removing and installing battery - AR54.10-P-0005EA
- Treatment of battery if vehicle taken out of service - AR54.10-P-0006EA
- Removing and installing cargo area connector box - AR54.10-P-0010A
- Preparing test with quiescent current retention unit - AR54.10-P-1030-01AC
- Preparing test without quiescent current retention unit - AR54.10-P-1030-02AC
- Testing quiescent current - AR54.10-P-1030-03AB
- Determining circuit with increased quiescent current consumption - AR54.10-P-1030-04AB
- Determine fused components with increased quiescent current consumption - AR54.10-P-1030-05AB
- Establishing unfused components with excessive quiescent current consumption - AR54.10-P-1030-06AB
- Check quiescent current consumption - AR54.10-P-1030AB
- Check battery; Risk of explosion caused by oxyhydrogen gas. Risk of poisoning and caustic burns caused by swallowing battery acid. Risk of injury caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries; Reduce increased voltage after charging process - AR54.10-P-1129-01A
- Check condition of battery - AR54.10-P-1129Z
- Charge battery - AR54.10-P-1130Z
- Disconnecting wiring at the fuse boxes or fuse blocks - AR54.15-P-1255-01EB
- Connecting wiring at the fuse boxes or fuse blocks - AR54.15-P-1255-02EB
- Separating/disconnecting electrical connectors in left footwell - AR54.15-P-1255-06EA
- Removing and installing fuse and relay box - AR54.15-P-1255EB
- Removing and installing fuse box in rear - AR54.15-P-1320A
- Repairing wiring harness using soldered terminal sleeve - AR54.18-P-0100-02A
- Repairing wiring harness - AR54.18-P-0100B
- Checking wiring harness - AR54.18-P-0600-01A
- Repair supplemental restraint system (SRS) squib wiring harness - AR54.18-P-0600A
- Removing control modules from control module box - AR54.20-P-1257-01A
- Removing and installing control module box - AR54.20-P-1257A
- Removing and installing multifunction control module - AR54.21-P-0001F
- Removing and installing combination switch - AR54.25-P-2800EA
- Removing and installing light module - AR54.25-P-3260A
- Withdrawing instrument cluster - AR54.30-P-6015-01Z
- Removing and installing instrument cluster - AR54.30-P-6015EA
- Removing and installing instrument cluster housing - AR54.30-P-6031EA
- Removing bulbs - AR54.30-P-6049-01Z
- Installing bulbs - AR54.30-P-6049-02Z
- Removing and installing bulbs in instrument cluster - AR54.30-P-6049EB
- Removing and installing outside temperature indicator sensor - AR54.30-P-6341EA
- Removing and installing outside temperature indicator sensor - AR54.30-P-6341EB
- Removing and installing claxon - AR54.35-P-1555EB
- Removing and installing Parktronic System (PTS) sensors in front bumper - AR54.65-P-0001A
- Removing and installing Parktronic System (PTS) sensors in rear bumper - AR54.65-P-0002A
- Removing and installing Parktronic system (PTS) warning indicator in instrument panel - AR54.65-P-0003A
- Removing and installing Parktronic system (PTS) warning indicator in rear dome lamp - AR54.65-P-0004A
- Removing and installing Parktronic system (PTS) switch - AR54.65-P-0005A
- Removing, installing Parktronic system (PTS) control module - AR54.65-P-0006A