  |
Removal, installation |
|
|
| 1 |
Disconnect ground lead from battery |
Insulate cable terminal on ground lead to protect against unintended contact between disconnected ground cable and ground point W10 |
AR54.10-P-0003A |
| 2 |
Unscrew screws (1) and remove cover (2) |
 Installation:
Ensure that cover gasket is in good condition and properly seated |
|
| 3 |
Remove control modules from control module box (F23/1) |
CFI control module (N3), relay module (K40), multifunction control module (N10-1), transmission control module (TCM, 5-speed automatic) (N15/1), transmission control module (TCM, N15-3), ASR/SPS control module (N47-1) and ETS/SPS control module (N47-2) |
AR54.20-P-1257-01A |
| 4 |
Loosen clamping screw (5) |
|
|
| 5 |
Unscrew screws (housing box) (4) and remove control module box (F23/1) (housing box) from component compartment |
Installation:
Ensure that gasket for control module box (housing box) is in good condition and properly seated |
|
| 6 |
Carefully pull connection leads for control modules into passenger footwell or component compartment |
When so doing pull cable grommets to component compartment off of control module box |
|
| 7 |
Unscrew screws (cable trough, 4) and remove control module box (F23/1, cable trough) from component compartment |
Installation:
Ensure that gasket for control module box (cable trough) is in good condition and properly seated |
|
| 8 |
Reinstall in opposite order |
|
|