Removing and installing light module - AR54.25-P-3260A

MODEL 208, 210 

Illustrated on model 210 

Fig 1: Identifying Light Module Components - Model 210

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removal, installation
1	Disconnect ground cable from battery	Insulate terminal on ground cable to prevent unintentional contact between disconnected ground cable and ground W10.	AR54.10-P-0003A
2	Unhook control cable on release lever for parking brake and remove release lever guide	Installation:  Clip release lever guide into mount on light module housing opposite direction of forward motion
3.1	Remove bottom section of instrument panel (driver's side)	Model 208	AR68.10-P-1505K
3.2	Remove cover below instrument panel (driver's side)	Model 210	AR68.10-P-1500F
4	Unhook and disconnect electrical connections (4) on rear of light module (N7-1)	Installation:  Complete electrical connections only after installing light module
5	Unscrew screws (3, 5)	Installation:  First screw in screw (3) in area of parking brake release lever. While screwing in support light module from below with hand and align on hole for second screw
6	Remove light module (N7/1) from instrument panel
	Assignments and lead connections for fuse blocks:	Model 208	GF54.15-P-1255EF
		Model 210	GF54.15-P-1255EA
7	Reinstall in opposite order