Section 5 (Engine Mechanical - 3.5L - Repair Instructions - Off Vehicle (1 Of 3))
WARNING: This page is about a different variant/trim than selected.
- Draining Fluids and Oil Filter Removal
- Crankshaft Balancer Removal
- Engine Flywheel Removal (Automatic Transmission)
- Engine Flywheel Removal (Manual Transmission)
- Drive Belt Tensioner Removal
- Engine Coolant Crossover Pipe Removal
- Engine Mount Support and Strut Bracket Removal
- Engine Mount Strut and Engine Lift Bracket Removal
- Oil Level Indicator and Tube Removal
- Oil Filter Adapter Removal
- Exhaust Crossover Pipe Removal
- Exhaust Manifold Removal - Left Side
- Exhaust Manifold Removal - Right Side
- Water Inlet and Engine Coolant Thermostat Removal
- Valve Rocker Arm Cover Removal - Left Side
- Valve Rocker Arm Cover Removal - Right Side
- Upper Intake Manifold Removal
- Lower Intake Manifold Removal
- Valve Rocker Arm and Push Rod Removal
- Valve Lifter Removal
- Water Pump Removal
- Cylinder Head Removal - Left Side
- Cylinder Head Removal - Right Side
- Oil Pan Removal
- Oil Pump Removal
- Camshaft Position Actuator Magnet Removal
- Oil Pump Drive Removal
- Crankshaft Front Oil Seal Removal
- Engine Front Cover Removal
- Timing Chain and Sprocket Removal
- Camshaft Removal
- Piston, Connecting Rod, and Bearing Removal
- Crankshaft Rear Oil Seal Removal
- Crankshaft and Bearing Removal
- Piston Oil Nozzle Removal
- Camshaft Bearing Removal
- Engine Block Disassemble
- Engine Block Heater Removal
- Engine Block Cleaning and Inspection
- Cylinder Boring and Honing
- Engine Block Assemble
- Engine Block Heater Installation
- Piston Oil Nozzle Cleaning and Inspection
- Crankshaft and Bearing Cleaning and Inspection
- Crankshaft Balancer Cleaning and Inspection
- Engine Flywheel Cleaning and Inspection
- Piston, Connecting Rod, and Bearing Cleaning and Inspection
- Camshaft and Bearings Cleaning and Inspection
- Camshaft Timing Chain and Sprocket Cleaning and Inspection
- Camshaft Position Actuator Magnet Cleaning and Inspection