LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2011 >> Impala LS, 3.9 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Mechanical - 3.5L - Repair Instructions - Off Vehicle (1 Of 3)) >> Valve Rocker Arm and Push Rod Removal

Valve Rocker Arm and Push Rod Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Valve Rocker Arm & Bolt
    GM1557679Courtesy of GENERAL MOTORS CORP.
  1. Loosen the valve rocker arm bolts.
    2. IMPORTANT: Place the valve train components in a rack in order to ensure that the components are installed in the same location from which they where removed.
  2. Remove the valve rocker arms.
  3. Remove the push rods.
    • The intake push rods measure 147.51 mm (5.81 in).
    • The exhaust push rods measure 154.87 mm (6.1 in).
    4. Fig 2: Identifying Intake Manifold Gaskets & Seals
    GM1557681Courtesy of GENERAL MOTORS CORP.
  4. Remove the intake manifold gaskets.
scientia non olet · About LEMON Manuals