Installing the trim on the bumper panel
- Position trim (1) and snap it into the detents (arrows).
Follow-up work
- Refer to INSTALLING THE REINFORCEMENT FOR THE LEFT AND RIGHT SIDE OF THE BUMPER COVER .
- Refer to INSTALLING THE SUPPORT AT THE BOTTOM CENTER .
- Refer to INSTALLING THE FRONT BUMPER COVER .
- Refer to INSTALLING THE FRONT ORNAMENTAL GRILLE/RADOME .
- Refer to INSTALLING THE FRONT RADIATOR GRILL FRAME .
- Refer to INSTALLING THE NUMBER PLATE BASEPLATE FOR THE LICENSE PLATE AT THE FRONT .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to CLOSING THE ENGINE COMPARTMENT LID .
- Refer to PUTTING THE FRONT RADAR SENSORS INTO OPERATION .