Remove instrument panel trim
NOTE:
TECHNICAL INFORMATION
Wheel alignment is not necessary after removal, installation or replacement.
Wheel alignment is not necessary after removal, installation or replacement.
Preliminary work
- Refer to ADJUSTING THE STEERING COLUMN POSITION .
- Refer to DEACTIVATING VEHICLE ELECTRICAL SYSTEM .
- Refer to REMOVING THE AIRBAG UNIT (SPORTS STEERING WHEEL) .
- Refer to REMOVING THE STEERING WHEEL (SPORTS STEERING WHEEL) .
- Refer to REMOVING STEERING COLUMN SHROUD UPPER SECTION .
- Refer to REMOVING STEERING COLUMN SHROUD LOWER SECTION .
- Refer to REMOVING THE STEERING COLUMN SWITCH CLUSTER (SZL) .
- Refer to REMOVING THE REAR CENTER CONSOLE TRIM .
- Refer to REMOVING THE CENTER ARMREST STORAGE COMPARTMENT .
- Refer to REMOVING CENTER ARMREST .
- Refer to REMOVING THE SPEAKER TRIM AT THE DASHBOARD .
- Refer to REMOVING CENTRAL INFORMATION DISPLAY (CID) .
- Refer to REMOVING CUP HOLDER .
- Refer to REMOVING THE WIRELESS CHARGING STORAGE .
- Refer to REMOVING THE CENTER STACK MODULE .
- Refer to REMOVING THE TRIM PANEL FOR PEDAL ASSEMBLY .
- Refer to REMOVING FOOTWELL TRIM PANEL ON THE RIGHT .
- Refer to REMOVING THE CENTER CONSOLE .
- Refer to REMOVING THE LEFT AND RIGHT A-PILLAR TRIM PANEL .
- Refer to REMOVING THE TRIM FOR THE HEAD-UP DISPLAY .
- Refer to REMOVING THE SIDE COVER ON THE LEFT AND RIGHT DASHBOARD .
- Refer to REMOVING THE DECORATIVE STRIP ON THE DASHBOARD AT LEFT AND RIGHT .
- Refer to REMOVING LIGHT OPERATING UNIT .
- Refer to REMOVING THE HEAD UNIT HIGH (HU-H) (WITH HOLDER). .
- Refer to REMOVING THE INSTRUMENT CLUSTER (KOMBI) .
- Refer to REMOVING THE MID-RANGE SPEAKER FROM THE DASHBOARD .
NOTE:
RISK OF DAMAGE
Damage of high-quality surfaces.
Plastic wedges can damage high-quality surfaces.
Damage of high-quality surfaces.
Plastic wedges can damage high-quality surfaces.
- Protect surfaces from damage.
- Release the screws (1)
in the region of the left and right A-pillars.
- Loosen screws (1)
.
- Release the screws (1) of the left-hand footwell, working from the rear.
- Loosen screws (2)
.
- Loosen screws (1)
.
- Release all plug connections and cable clips (arrows) behind the glove compartment.
- Unscrew the screws (1)
at the right side of the glove compartment, working from the rear.
- Open glovebox.
- Loosen screws (1) .
NOTE:
TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Conduct the following operation with the assistance of a second person.