Section 12 (Rear Final Drive 0BC, 0BD, 0BE & 0BF)
WARNING: This page is about a different variant/trim than selected.
- 39 Final Drive, Differential
- General Information
- Description And Operation
- Driveshaft, Bolts On Transmission Side Overview
- Driveshaft, Mounted On Transmission Side Overview
- Final Drive 0BC, 0BD Overview
- Final Drive 0BE, 0BF Overview
- Final Drive 0BF Overview
- Gear Oil Drain And Inspection Plugs Overview, 0BF
- Gear Oil Drain And Inspection Plugs Overview, 0BE, 0BF
- Seals Component Location Overview, 0BC, 0BD
- Seals Component Location Overview, 0BE, 0BF
- Transmission Control Component Location Overview
- Specifications
- Diagnosis And Testing
- Removal And Installation
- AWD Control Module -J492-
- All Wheel Drive Clutch Valve -N445- OR All Wheel Drive Clutch Valve 2 -N446-, 0BE, 0BF
- All Wheel Drive Pump -V415-, 0BE, 0BF
- ADDITIONAL WORK AFTER REPLACING All Wheel Drive Control Module -J492-
- Boot, Replacing, Driveshaft Connected On Transmission Side
- Driveshaft, Driveshaft Connected On Transmission Side
- Driveshaft, Driveshaft Bolted On Transmission Side
- Driveshaft, Bolts On Transmission Side
- Driveshaft, Removing From Rear Final Drive And Installing
- Final Drive
- Flange Input Shaft Ring, Replacing
- Flange Shaft Protective Ring, Replacing
- Hydraulic Control Module, 0BE, 0BF
- Oil Pressure/Temperature Sensor -G437- OR Oil Pressure/Temperature Sensor 2 -G640-, 0BE, 0BF
- Left Seal, Replacing
- Input Shaft Seal, Replacing
- Disassembly And Assembly
- Special Tools