Final Drive 0BC, 0BD Overview: Notes
WARNING: This page is about a different variant/trim than selected.
Rear Final Drive
- Subframe
- Removing and installing, refer to SUBFRAME .
- Bolt
- 95 Nm
- Bolt
- 55 Nm
- Bolt
- 55 Nm
- Depending on the date of manufacture for the balance weight mounting Balance Weight on the Rear Final Drive
- Heat Shield
- Bolt
- 20 Nm
- Drive Axle
- Removing and installing, refer to DRIVE AXLE
- Rear Final Drive
- Versions with balance weight Balance Weight on the Rear Final Drive
- Removing and installing, refer to FINAL DRIVE
- Driveshaft
- Removing and installing, refer to DRIVESHAFT, DRIVESHAFT CONNECTED ON TRANSMISSION SIDE or DRIVESHAFT, DRIVESHAFT BOLTED ON TRANSMISSION SIDE .
- Removing and installing on the rear final drive, refer to DRIVESHAFT, REMOVING FROM REAR FINAL DRIVE AND INSTALLING
- Crossmember