LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> A6 2.0T >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Rear Final Drive 0BC, 0BD, 0BE & 0BF) >> 39 Final Drive, Differential >> Removal And Installation >> Left Seal, Replacing >> Left Seal, Replacing, 0BE, 0BF >> Removing

Left Seal, Replacing, 0BE, 0BF: Removing

WARNING: This page is about a different variant/trim than selected.

-- General Repair Instructions. Refer to REPAIR INFORMATION .

-- Remove the rear final drive. Refer to FINAL DRIVE .

-- Remove the flange shaft bolt. To do this, install two bolts into the flange and counterhold the flange shaft using an assembly lever.

Fig 1: Identifying Flange Shaft Bolt, Removal
GWWA39-10380Courtesy of AUDI OF AMERICA, LLC

-- Remove flange shaft.

NOTE:

If it not possible to remove the flange shaft by hand, then use Slide Hammer-Complete SetVW 771 to remove it.

-- Remove the flange shaft seal using Slide Hammer-Complete SetVW 771 and Additional Part for VW 771VW 771/37.

Fig 2: Identifying Flange Shaft Seal, Removal
GWWA39-10381Courtesy of AUDI OF AMERICA, LLC