Input Shaft Seal, Replacing, 0BC: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- PullerVW 391
- AdapterVW 771/40 from the Slide Hammer-Complete SetVW 771.
- Retainer3028
- PullerT10055
- AdapterT10055/2
- Thrust PieceT40109
- Assembly ToolT40222/1
- Sealing GreaseG 052 128 A1
- two bolts M 8 x 30
- One M 8 x 45 bolt