LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> Cayman GTS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (55 - Lids, Flaps) >> WM 559037 Disassembling And Assembling Rear Lid (All Models) >> Subsequent Work

Subsequent Work

WARNING: This page is about a different car, the 2010 Porsche Cayenne, 2009 Porsche Cayenne, and 2008 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install rear window release → Installing Bottom Section For Rear Window Release .
  2. Install wiper motor for rear window wiper system → Installing Wiper Motor For Rear Window Wiper System .
  3. Install number plate light → Installing Number Plate Light .
  4. Install release for rear lid → Installing Release For Rear Lid 
  5. Install upper part of rear lock → Installing Upper Part Of Rear Lock  .
  6. Install wire harness on rear lid → Installing wiring harness tailgate
  7. Install tilt sensor on rear lid → Installing Tilt Sensor For Rear Lid  .
  8. Install buzzer on rear lid → Installing Rear Lid Buzzer  .
  9. Install moulding for rear lid → Installing moulding for rear lid
  10. Install rear window seal → Installing Rear Window Seal .
  11. Install rear window → Installing Rear Window .
  12. Install rear spoiler → Installing rear spoiler .
  13. Remove trim panels for rear lid → Installing lining for rear lid .
  14. Install rear lid. → Installing Rear Lid  .
scientia non olet · About LEMON Manuals