Lights, Lamps, Switches Interior, Theft Protection - 911 Turbo (996)

• Removing and installing signal converter/immobilizer
  • Removing signal converter/immobilizer
  • Installing signal converter/immobilizer
• Removing and installing passenger compartment monitoring sensor
  • Removing and installing passenger compartment monitoring sensor
• Additional alarm system M 536
  • Notes
  • Removing alarm siren and tilt sensor
• Radio remote control in hand-held transmitter does not function
  • Notes
  • Empty battery in hand-held transmitter
  • Radio transmitter outside lock-in range
  • Atmospheric interference or interfering transmitters
  • Energy-saving mode active
  • Fault in hand-held transmitter or vehicle
• Bulb table and installation instructions
  • Bulb table
  • Installing bulbs
• Removing and installing bulb for door warning light
  • Removing bulb for door warning light
  • Installing bulb for door warning light
• Removing and installing bulb for luggage compartment light
  • Removing bulb for luggage compartment light
  • Installing bulb for luggage compartment light
• Removing and installing bulb for interior light
  • Removing bulb for interior light
  • Installing bulb for interior light
• Removing and installing bulb for engine compartment light
  • Removing bulb for engine compartment light
  • Installing bulb for engine compartment light
• Teaching hand-held transmitter
  • General
  • Work preparation
  • Procedure
• Disassembling and assembling hand-held transmitter
  • Notes
  • Removing key from the bottom part
  • Installing key in the bottom part
• Removing and installing relay for main switch - GT2, as of MY 2001
  • Notes
  • Installing the main battery relay
  • Installing inner EMERGENCY STOP switch
  • Removing the main battery relay
  • Removing the inner EMERGENCY STOP switch
  • Operating the main battery switch
    • Status - A - Road. Status - B - Racing track
    • Actuating inner EMERGENCY STOP switch
    • Moving the EMERGENCY STOP switch to its starting position
• Removing and installing control unit for alarm system
  • Notes
  • Removing control unit for alarm system
  • Installing control unit for alarm system
  • Teaching control unit for the alarm system
• Converting installation position for tilt sensor, additional alarm system M536
  • Notes
  • Tools