Removing the inner EMERGENCY STOP switch

The necessary EMERGENCY STOP switch is installed depending on the additional equipment present:

EMERGENCY STOP switch in the centre console M 581. 

Fig 1: Identifying Emergency Stop Switch In Centre Console - GT2, As Of MY 2001

Courtesy of PORSCHE OF NORTH AMERICA, INC.

EMERGENCY STOP switch - without centre console M 581 - in front of shift lever. 

Fig 2: Identifying Emergency Stop Switch - Without Centre Console - GT2, As Of MY 2001

Courtesy of PORSCHE OF NORTH AMERICA, INC.

1. Carefully unclip the cover trims with the EMERGENCY STOP switch upwards with a suitable tool (e.g. screwdriver; plastic spatula).
2. Disconnect the 3-pin plug connection connected to the EMERGENCY STOP switch from the wiring harness by pushing and pulling. Insert the wiring harness which is marked with a white identification tape - A - into the shaft in the centre console. Clip the standard cover - without EMERGENCY STOP switch - into place.
   Fig 3: Disconnecting 3-Pin Plug Connection To The Emergency Stop Switch - GT2, As Of MY 2001

   Courtesy of PORSCHE OF NORTH AMERICA, INC.