Section 95 (Fuel And Emissions Systems)
WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
- Special Tools
- General Troubleshooting Information
- DTC Troubleshooting Index
- Symptom Troubleshooting Index
- System Description
- Fuel and Emissions Systems Diagram
- Vacuum Hose Routing
- Electronic Control Systems
- PCM Inputs and Outputs at PCM Connector A (□) (49P)
- PCM Inputs and Outputs at PCM Connector B (Δ ) (49P)
- PCM Inputs and Outputs at PCM Connector C (◦) (49P)
- PGM-FI System
- Notes
- Alternator Control
- Air Conditioning (A/C) Compressor Clutch Relay
- Air Fuel Ratio (A/F) Sensor
- Barometric Pressure (BARO) Sensor
- Camshaft Position (CMP) Sensor
- Crankshaft Position (CKP) Sensor
- Engine Coolant Temperature (ECT) Sensor 1 and 2
- Ignition Timing Control
- Injector Timing and Duration
- Knock Sensor
- Malfunction Indicator Lamp (MIL) Indication (In relation to Readiness Codes)
- Manifold Absolute Pressure (MAP) Sensor
- Mass Air Flow (MAF) Sensor/Intake Air Temperature (IAT) Sensor
- Output Shaft (Countershaft) Speed Sensor
- Secondary Heated Oxygen Sensor (Secondary HO2S)
- Starter Control System Diagram
- Electronic Throttle Control System
- Electronic Throttle Control System Diagram
- VTEC System
- VTEC System Operation
- Idle Control System
- Fuel Supply System
- Catalytic Converter System
- Exhaust Gas Recirculation (EGR) System
- Exhaust Gas Recirculation (EGR) System Diagram
- Positive Crankcase Ventilation (PCV) System
- Evaporative Emission (EVAP) Control System
- Evaporative Emission (EVAP) Control Diagram
- Fuel Cap Warning Message
- How to clear the message with the HDS
- How to clear the message without the HDS
- How to Set Readiness Codes
- Malfunction Indicator Lamp (MIL) Indication (In relation to Readiness Codes)
- Catalytic Converter Monitor and Readiness Code
- Evaporative Emission (EVAP) Control System Monitor and Readiness Code
- Air Fuel Ratio (A/F) Sensor Heater Monitor Readiness Code
- Misfire Monitor and Readiness Code
- Fuel System Monitor and Readiness Code
- Comprehensive Component Monitor and Readiness Code
- EGR Monitor and Readiness Code