LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Fuel And Emissions Systems) >> How to Set Readiness Codes >> EGR Monitor and Readiness Code >> Procedure

EGR Monitor and Readiness Code: Procedure

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the HDS to the DLC.
  2. Start the engine.
  3. Drive at a steady speed with the transmission in D, at 50-62 mph (80-100 km/h) or above for more than 10 seconds.
  4. With the transmission in D, decelerate from 62 mph (100 km/h) or above by completely releasing the throttle for at least 5 seconds. If the engine is stopped during this step, repeat steps  3 and  4.
  5. Check the OBD status screen for DTC P0401 in the DTCs MENU with the HDS.
    • If it is passed, readiness is complete.
    • If it is not passed, go to step  3 and retest.
scientia non olet · About LEMON Manuals