LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Fuel And Emissions Systems) >> How to Set Readiness Codes >> Catalytic Converter Monitor and Readiness Code >> Notes

Catalytic Converter Monitor and Readiness Code: Notes

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • During the procedure, do not turn the ignition switch to ACC (I) or LOCK (0).
  • All readiness codes are cleared when the battery is disconnected, if DTCs have been cleared, or if the PCM is reset with the HDS.
  • Low ambient temperatures or excessive stop-and-go traffic may increase the drive time needed to switch the readiness code from incomplete to complete.
  • The readiness code will not switch to complete until all the enable criteria are met.
  • If a fault in the secondary HO2S system caused the MIL to come on, the readiness code cannot be set to complete until you correct the fault.
scientia non olet · About LEMON Manuals