Section 9 (Twin Clutch SPORTRONIC Shift Transmission (TC-SST) Overhaul - Lancer)

• General Description
  • Transaxle Model
• General Specification
  • Gear Ratio Table
• Fastener Tightening Specification
  • Transaxle
  • Transfer
• Sealants And Adhesives
  • Notes
  • Form-In-Place Gasket (FIPG)
  • Disassembly
  • Surface Preparation
  • FIPG Application
• Lubricant
• Special Tools
• Transaxle
  • Disassembly And Reassembly
    • Notes
    • Removal Service Points
      • << A >> Transaxle Case Oil Seal (RH)/Transaxle Case Oil Seal (LH) Removal
      • << B >> Seal Cover Bracket/Seal Cover Removal
      • << C >> Clutch Assembly Removal
      • << D >> Oil Pan Assembly Removal
      • << E >> MECHATRONIC Assembly Removal
      • << F >> Manual Control Shaft Removal
    • Installation Service Points
      • >> A << Oil Filter Bracket Assembly Installation
      • >> B << Manual Control Shaft Installation
      • >> C << Gasket A/Gasket C/MECHATRONIC Assembly Installation
      • >> D << Oil Pan Assembly Installation
      • >> E << Needle Roller Bearing Installation
      • >> F << Seal Ring Installation
      • >> G << Clutch Assembly Installation
      • >> H << Seal Cover Bracket/Seal Cover Installation
      • >> I << Transaxle Case Oil Seal (LH) Installation
      • >> J << Transaxle Case Oil Seal (RH) Installation
      • >> K << V Ring Installation
• Transfer
  • Disassembly And Assembly
    • Notes
    • Assembly Service Point
      • >> A << Cover Installation
      • >> B << Oil Seal Installation
      • >> C << Oil Seal Installation