Chassis Electrical - 1 Of 5
- Component Index
- Battery
- Ignition Switch
- Combination Meter
- Service Specifications
- Special Tools
- Combination Meters Diagnostic
- Standard Flow Of Diagnostic Troubleshooting
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- Trouble Judgment
- Troubleshooting Hints
- Diagnosis
- DTC B1201: Abnormal fuel information
- DTC B1208: Malfunction of LCD heater
- DTC B1209: Test mode
- DTC B2203: Chassis No. not programmed
- DTC B2463: The sticking of rheostat switch
- DTC B2464: The sticking of meter information switch
- DTC B2465: Ignition switch signal error
- DTC U0019: Bus off (CAN-B)
- DTC U0100: Engine control module CAN timeout
- DTC U0141: ETACS CAN timeout
- DTC U0151: SRS-ECU CAN timeout
- DTC U0154: Occupant classification-ECU CAN timeout
- DTC U0164: A/C-ECU CAN timeout
- DTC U0168: KOS-ECU or WCM CAN timeout
- DTC U0184: Audio CAN timeout
- DTC U0197: Hands free module CAN timeout
- DTC U0245: Audio visual navigation unit CAN timeout
- DTC U1415: Coding not completed/Data fail
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Power supply circuit check.
- Inspection Procedure 2: The speedometer does not work (the other meters work).
- Inspection Procedure 3: The tachometer does not work (the other meters work).
- Inspection Procedure 4: Tone alarm does not sound normally.
- Inspection Procedure 5: The combination meter light does not illuminate normally or the multi information display is not displayed normally.
- Inspection Procedure 6: The multi information display screen cannot be changed with the operation of the meter information switch.
- Service Data
- Actuator Test Table
- Check Procedure For Each Multi Information Display Screen
- Check At Ecu Terminals
- On-Vehicle Service
- Service Reminder Function Set
- How To Set By Operating The Scan
- Tool MB991958
- How To Operate The Scan Tool MB991958
- Relationship between the elapsed months and the elapsed days which are used by the service reminder function
- How To Set By Special Operation Of Switch
- How To Cancel The Service Reminder Warning
- How To Set The Schedule
- Schedule Table
- How To Inactivate The Service Reminder Function
- How To Set By Operating The Scan
- Combination Meter