Speedometer Check

Adjust the pressure of tires to the specified level (Refer to ON-VEHICLE SERVICE ).
Where applicable, ensure that the TPMS warning light is not illuminating or flashing.
CAUTION: Do not accelerate or decelerate suddenly during servicing work.

CAUTION: Set a free-roller on the rear tire for AWD.
For FWD vehicles, set the vehicle onto a speedometer tester and use wheel chocks to hold the rear wheels.

Fig 1: Holding Rear Wheels Using Wheel Chocks
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
For AWD vehicles, set the vehicle onto a speedometer tester and place the rear wheels on a free roller.

Fig 2: Placing Rear Wheels On Free Roller
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
To prevent the wheel from moving from side to side, attach tension bars to the tie-down hook, and secure both ends to anchor plates.
To prevent the vehicle from moving, attach a chain or wire to the rear retraction hook, and make sure the end of the chain or wire is secured.

Fig 3: Identifying Anchor Plate And Puller
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Check if the speedometer indicator range is within the standard values.

Standard value < Except vehicles for CANADA >:

DIAGNOSIS PROCEDURE

Standard value < Vehicles for CANADA >:

DIAGNOSIS PROCEDURE

If not within the standard value, check the tire size. If an incorrect size of tire is used, replace it and check again. If the tire size is correct, a defect may be present in components and circuit between the ABS or ASC and the combination meter. Check the following items.
- ABS or ASC (refer to DIAGNOSTIC TROUBLE CODE CHART < ABS > or DIAGNOSTIC TROUBLE CODE CHART < ASC >).
- Combination meter (refer to DIAGNOSTIC TROUBLE CODE CHART ).