LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Chassis Electrical - 1 Of 5 >> Combination Meter >> Combination Meters Diagnostic >> Check Procedure For Each Multi Information Display Screen >> Warning Screen

Warning Screen

When malfunctions occur to the vehicle, the following warning screens are displayed. If these screens are not displayed normally or if they continue to be displayed even after the factor is eliminated, take measures according to the action procedure.

WARNING SCREEN CHART

Display contents Factor Action procedure
G05396720Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed with the sounding of tone alarm when the driver's door is opened with the key inserted in the ignition switch key cylinder. If ignition key reminder warning tone alarm is not being sounded, perform troubleshooting for ignition key reminder warning tone alarm (Refer to INSPECTION PROCEDURE 4: TONE ALARM DOES NOT SOUND NORMALLY.  ).
G05396721Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed with the sounding of tone alarm when the driver's door is opened with the ignition switch at the LOCK (OFF) or ACC position and the lighting switch at the tail or head position. If the lighting monitor warning tone alarm is not being sounded, perform the troubleshooting for the lighting monitor warning tone alarm (Refer to INSPECTION PROCEDURE 4: TONE ALARM DOES NOT SOUND NORMALLY.  ).
G05396722Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  • Displayed while the theft alarm is in operation.
  • Immobilizer is registered.
 If the warning screen is not displayed normally or if the screen continues to be displayed, carry out the troubleshooting for the theft alarm (Refer to HOW TO DIAGNOSE THE CAN BUS LINES ) or immobilizer system (Refer to TROUBLE SYMPTOM CHART < vehicles with KOS > or Refer to TROUBLE SYMPTOM CHART < vehicles without KOS >).
G05385235Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed when a malfunction occurs to KOS. Refer to TROUBLE SYMPTOM CHART .
  1. Displayed when the following operations are carried out with the ignition switch at positions other than the LOCK (PUSH OFF) position after the engine is stopped.
    • When the driver's door is opened
    • When the doors are closed and locked
  2. Displayed if carrying a KOS key with different ID code or the KOS key is outside the operative range.
  3. Displayed when the KOS key removal monitoring function or KOS key confinement prevention function is in operation.
  4. Displayed when the door ajar prevention function is in operation.
  5. Displayed when there is a malfunction to KOS.
 If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the KOS (Refer to DIAGNOSTIC TROUBLE CODE CHART ).
G05385236Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Displayed when the tire air pressure is an abnormality. (except spare tire)
  2. Displayed when the TPMS is an abnormality.
 If the warning screen is not displayed normally or erased, carry out the troubleshooting for the TPMS (Refer to DIAGNOSTIC TROUBLE CODE CHART ).
G05434236Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Displayed when the brake fluid amount is insufficient or a malfunction occurs to the brake device.
  2. Displayed if vehicle is driven with the parking brake engaged.
 If the warning screen is not displayed normally or if the screen continues to be displayed, take the following measures for each displayed item.
  1. Check the brake fluid or brake device. Refer to DISC BRAKE PAD CHECK AND REPLACEMENT .
  2. Check the parking brake. Refer to PARKING BRAKE SWITCH CHECK .
G05434237Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed when a malfunction occurs to the anti-lock braking system (ABS). If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the ABS. Refer to SYMPTOM CHART .
G05434238Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 If any of the doors or liftgate is not closed completely, the location of the ajar door is displayed with the sounding of tone alarm. If the door ajar warning tone alarm does not sound, perform the troubleshooting for the door ajar warning tone alarm. Refer to INSPECTION PROCEDURE 4: TONE ALARM DOES NOT SOUND NORMALLY.  .
G05396728Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Displayed when the hood is open.
  2. Displayed when there is a malfunction to the hood.
 If the warning screen is not displayed normally, or if the screen continues to be displayed, check the hood latch switch input signal. Refer to INSPECTION PROCEDURE 10: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE HOOD SWITCH. .
G05396729Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed when overheated. If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the engine. Refer to SYMPTOM CHART < 2.4 L engine > or SYMPTOM CHART < 3.0 L engine >.
G05434241Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Displayed when the transmission oil temperature becomes high.
  2. Displayed when there is a malfunction to the CVT or automatic transaxle.
 If the warning screen is not displayed normally or if the screen continues to be displayed, check the CVT or automatic transaxle diagnostic trouble code. Refer to DIAGNOSIS CODE CHART < CVT > or DIAGNOSTIC TROUBLE CODE CHART < automatic transaxle >.
G05396731Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed when the ignition switch is turned ON without the driver's seat belt fastened. If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the seat belt reminder warning light. Refer to INSPECTION PROCEDURE 5: THE COMBINATION METER LIGHT DOES NOT ILLUMINATE NORMALLY OR THE MULTI INFORMATION DISPLAY IS NOT DISPLAYED NORMALLY.  .
G05434243Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Displayed when there is a malfunction to the fuel system.
  2. Displayed when the remaining fuel amount is small.
 If the warning screen is not displayed normally or if the screen continues to be displayed, take the following measures for each displayed item.
  1. Check the combination meter diagnostic trouble code. Refer to INSPECTION PROCEDURE 5: THE COMBINATION METER LIGHT DOES NOT ILLUMINATE NORMALLY OR THE MULTI INFORMATION DISPLAY IS NOT DISPLAYED NORMALLY.  .
  2. Immediately fill the fuel.
G05396733Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed when there is a malfunction to the engine oil circulation system. If the warning screen is not displayed normally or if the screen continues to be displayed, check the engine oil amount. Refer to SYMPTOM CHART < 2.4 L engine > or SYMPTOM CHART < 3.0 L engine >.
G05396734Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed when there is a malfunction to the charging system. If the warning screen is not displayed normally or if the screen continues to be displayed, check the battery. Refer to BATTERY CHARGING  .
G05396735Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed when there is a malfunction to the SRS air bag or to the pre-tensioner mechanism. If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the SRS air bag/pre-tensioner mechanism warning light. Refer to CHECK CHART FOR DIAGNOSIS CODES .
G05434247Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed when there is a malfunction to the headlight automatic leveling function. If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the headlight automatic leveling function. Refer to TROUBLE SYMPTOM CHART .
G05396736Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed when there is a malfunction to the ASC. If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the ASC. Refer to SYMPTOM CHART .
G05434249Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Displayed when there is a malfunction to the electronically-controlled AWD system or multi-select AWD.
  2. Displayed when there is a malfunction to the electronically-controlled AWD differential or when the multi-select AWD system temperature is high.
 If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the electronically-controlled AWD system. Refer to DIAGNOSIS CODE CHART .
G05434250Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
 Displayed with the sounding of tone alarm when the ambient temperature is 37°F (3°C) or less. If the freeze warning tone alarm does not sound with the ambient temperature of 37°F (3°C) or less, perform the troubleshooting for the freeze warning tone alarm. Refer to INSPECTION PROCEDURE 4: TONE ALARM DOES NOT SOUND NORMALLY.  .
scientia non olet · About LEMON Manuals