Remove/Install Front Headliner - AR68.30-S-7607E

Model 447, 448 

Courtesy of MERCEDES-BENZ USA

Shown On model 447.8 With Code FS5 (Illuminated mirror for sun visors) and Except Code ZK7 (MARCO POLO equipment line) 

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Notice	Notes on carrying out repair work in the vehicle interior		AH68.00-D-0001-01KOS
	Remove/install
1.1	Remove overhead control panel control unit (N70)	Model 447.6/7 with code LD0 (Overhead control panel with two reading lights) Model 447 with code LC4 (Comfort overhead control panel) Model 448	AR82.20-S-1100E
1.2	Remove front dome lamp	Model 447.6/7 except code LC4 (Comfort overhead control panel) except code LD0 (Overhead control panel with two reading lights)	AR82.20-S-0110E
2	Remove rear air conditioning/rear heater control and operating unit	Model 447.8 with code HZ7 (TEMPMATIC semi-automatic air conditioning in rear) Model 448.8	AR83.50-S-9071E
3	Unclip cover (8)	Long wedge	Fig 1
4	Remove grab of handles (1)		AR68.30-S-4330E
5	Remove sun visors (2)		AR68.60-S-5480E
6	Remove vanity mirror lamps (6)	Model 447, 448 with code FS5 (Illuminated vanity mirrors for sun visors)	AR82.20-S-5582E
7	Remove bracket (3) of sun visor (2)	For this purpose loosen covers (4) and unscrew bolts (3).
8	Remove trim from left and right A-pillar		AR68.30-S-4050E
9	Remove upper paneling from pop-up roof cutout	Model 447.7/8 with code ZK9 (Lifting roof hatch) Model 447.8 with code ZK0 (EASY UP pop-up roof, electric)	AR77.70-S-0020E
10	Unscrew bolts (9)
11	Remove screws/bolts (11)	Model 447 as of 1/29/15 with code ZK0 (EASY UP pop-up roof, electric) Model 447 as of 1/29/15 with code ZK9 (Lifting roof hatch)
12	Remove bracket (12)	Model 447.7/8 with code SH9 (Window airbag for driver and codriver) with code ZK9 (Lifting roof hatch) Model 447.8 with code SH9 (Window airbag for driver and codriver) with code ZK0 (EASY UP pop-up roof, electric) To do this, remove screw/bolts (10).
13	Loosen front roof paneling (7) and remove toward front	Carefully detach front headliner (7). Otherwise the front headliner (7) can be damaged. Ensure that front headliner (7) is seated correctly in rear headliner, at B-pillar panelings and in the sealing frames of the front doors.
14	Make cutouts in new front headliner (7)	When replacing front headliner (7). Depending on the equipment variant or accessories, the new front headliner (7) must be equipped with additional cutouts.	AR68.30-S-4305-15E
15	Install in the reverse order
	Check
16	Check electrical components in repair area for proper function

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA