Remove/Install Paneling On A-Pillar - AR68.30-S-4050E

Model 447, 448 

Show on right side of vehicle With Code SH9 

(window airbag for driver and front passenger) 

Except Code XM7 (facelift II) 

Courtesy of MERCEDES-BENZ USA

Notice	General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment	Model 447 with engine 780	AH00.00-Z-0300-01A
Notice	Notes on carrying out repair work in the vehicle interior		AH68.00-D-0001-01KOS
	Remove/install
1	Remove the cover (2).	Model 447, 448 with code SH8 (Window airbags for driver, front passenger and rear) Model 447, 448 with code SH9 (Window airbag for driver and codriver) Long wedge	Fig 1
2	Remove the screw (3).	Model 447, 448 with code SH8 (Window airbags for driver, front passenger and rear) Model 447, 448 with code SH9 (Window airbag for driver and codriver)
3	Remove respective trim (1).	To do so, unclip the trim (1) from above. Ensure that the cover (1) is seated correctly in the mounts (4). Ensure that sealing frame (5) is installed correctly.	multimedia:A supplement to the article is available.
4	Install in the reverse order.

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA