Gasoline injection and ignition system (ME-SFI ) - Diagnosis - Diagnostic trouble code memory (Fault Codes P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0325, P0330, P0335, P0341, P0370, P0400, P0410, P0422, P0432, P0440, P0441, P0442, P0443, P0446, P0450, P0455, P0460, P0500, P0507, P0560, P0565, P0600, P0604, P0605) - AD07.61-P-4000AA
ENGINES 112.910,
112.911 up to 31.5.00,
112.920,
112.921 up to 31.5.00,
112.923,
112.940 /941 /942 up to 31.5.00,
112.943
Fault codes from P0300 to P0699
| Hazard from contact with parts conducting high voltages. | Do not touch parts which conduct high voltages. Persons who wear electronic implants (e.g. heart pacemakers) must not carry out work on the ignition system. | AS15.10-Z-0001-01A | |
| Lethal hazard from being drawn into rotating vehicle parts | Do not reach into rotating parts. Wear closed and close-fitting work clothes. Secure area of rotating vehicle components against unauthorized access. |
AS00.00-Z-0004-01A | |
| Risk of explosion from fuel igniting, risk of poisoning from inhaling and swallowing fuel as well as risk of injury to eyes and skin from contact with fuel. | No fire, sparks, naked flames or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel. |
AS47.00-Z-0001-01A | |
| Notes on avoiding damage to the ignition system | Engines 104, 111, 112, 113, 119, 120 with ME-SFI fuel injection and ignition system | AH15.10-P-0002-01D | |
| The fault code cannot be read out with the pulse counter | |||
| ■ Symbol for USA vehicles for activation of the malfunction indicator lamp CHECK ENGINE • Symbol for EURO3 vehicles for activation of the engine diagnosis malfunction indicator lamp (is indicated in the HHT as ■) The malfunction indicator lamp does not go on until a fault relevant for the exhaust system was stored during the last driving cycle (exception misfire "damaging to TWC", malfunction indicator lamp goes on immediately). |
|||
| Ignition: On | |||
| Connect hand-held-tester (HHT), read out diagnostic trouble code memory | AD00.00-P-2000-03A | ||
| Gasoline injection and ignition system (ME-SFI ) - diagnosis - previous knowledge | AD07.61-P-2000A | ||
| Check and adjust engine | Engine diagnosis manual | ||
| Diagnostic trouble code memory | |||
| Fault code |
Possible cause | Note | Remedy |
| No fault code | No fault detected | Depending on the complaint, carry out testing of ME-SFI electrical system in full | AD07.61-P-6000A |
| AD07.61-P-6001A | |||
| 112.942 in MODEL 163.154 up to 31.5.98 | AD07.61-P-6002A | ||
| AD07.61-P-6003A | |||
| AD07.61-P-6004C | |||
| P0300 ■ • | A Misfire | AD07.61-P-6001-11A | |
| B Misfire "damaging to TWC" | AD07.61-P-6001-12A | ||
| AD07.61-P-6001-13A | |||
| AD07.61-P-6001-14A | |||
| AD07.61-P-6001-15A | |||
| AD07.61-P-6001-16A | |||
| AD07.61-P-6001-17A | |||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11A | ||
| P0301 ■ • | A Misfire in cylinder 1 | AD07.61-P-6001-11A | |
| B Misfire in cylinder 1 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0302 ■ • | A Misfire in cylinder 2 | AD07.61-P-6001-12A | |
| B Misfire in cylinder 2 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0303 ■ • | A Misfire in cylinder 3 | AD07.61-P-6001-13A | |
| B Misfire in cylinder 3 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0304 ■ • | A Misfire in cylinder 4 | AD07.61-P-6001-14A | |
| B Misfire in cylinder 4 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0305 ■ • | A Misfire in cylinder 5 | AD07.61-P-6001-15A | |
| B Misfire in cylinder 5 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0306 ■ • | A Misfire in cylinder 6 | AD07.61-P-6001-16A | |
| B Misfire in cylinder 6 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0325 | Knock sensor on right | Connector line | |
| Knock sensor | |||
| Knock sensor, fault code description ME-SFI | AD07.61-P-4000-12A | ||
| P0330 | Knock sensor on left | Connector line | |
| Knock sensor | |||
| Knock sensor, fault code description ME-SFI | AD07.61-P-4000-12A | ||
| P0335 ■ • | Crankshaft position sensor (L5) | AD07.61-P-6001-09A | |
| Crankshaft position sensor, fault code description ME-SFI | AD07.61-P-4000-13A | ||
| P0341 ■ • | Camshaft Hall sensor (B6/1) | AD07.61-P-6001-10A | |
| Camshaft Hall sensor, fault code description ME-SFI | AD07.61-P-4000-14A | ||
| P0370 | Angle deviation for camshaft to crankshaft | Check basic adjustment of camshafts | |
| P0400 ■ | Exhaust gas recirculation malfunction (causal chain) | AD07.61-P-6000-27A | |
| Exhaust gas recirculation malfunction (causal chain), fault code description ME-SFI | AD07.61-P-4000-50A | ||
| P0410 ■ • | Secondary air injection malfunction (causal chain) | AD07.61-P-6000-24A | |
| AD07.61-P-6000-25A | |||
| AD07.61-P-6000-26A | |||
| Secondary air injection malfunction (causal chain), fault code description ME-SFI | AD07.61-P-4000-15A | ||
| P0422 ■ • | Effect of right three-way catalytic converter too low | Right three-way catalytic converter | |
| Three-way catalytic converter effect too low, fault code description ME-SFI | AD07.61-P-4000-16A | ||
| P0432 ■ • | Effect of left three-way catalytic converter too low | Left three-way catalytic converter | |
| Three-way catalytic converter effect too low, fault code description ME-SFI | AD07.61-P-4000-16A | ||
| P0440 ■ | Purge system leak (causal chain) | AD07.61-P-6000-30A | |
| AD07.61-P-6000-31A | |||
| Purge system leak (causal chain), fault code description ME-SFI | AD07.61-P-4000-17A | ||
| P0441 ■ | Purge control valve (Y58/1) Function | AD07.61-P-6000-29A | |
| AD07.61-P-6000-30A | |||
| Purge system leak (causal chain), fault code description ME-SFI | AD07.61-P-4000-17A | ||
| P0442 ■ | Purge system slight leak | AD07.61-P-6000-31A | |
| Purge system leak (causal chain), fault code description ME-SFI | AD07.61-P-4000-17A | ||
| P0443 ■ • | Purge control valve (Y58/1) | AD07.61-P-6000-29A | |
| Purge control valve, fault code description ME-SFI | AD07.61-P-4000-19A | ||
| P0446 ■ | A Activated charcoal canister shutoff valve (causal chain) | AD07.61-P-6000-32A | |
| B Shutoff valve for activated charcoal canister (Y58/4) | AD07.61-P-6000-33A | ||
| Activated charcoal canister shutoff valve, fault code description ME-SFI | AD07.61-P-4000-20A | ||
| P0450 ■ | A Tank pressure sensor (B4/3) electrical fault B Tank pressure sensor (B4/3), signal oscillates |
AD07.61-P-6000-33A Activated charcoal canister blocked |
|
| Tank pressure sensor, fault code description ME-SFI | AD07.61-P-4000-21A | ||
| P0455 ■ | Purge system with severe leak or voltage supply for tank pressure sensor (B4/3) | AD07.61-P-6000-31A AD07.61-P-6000-33A |
|
| Purge system leak (causal chain), fault code description ME-SFI | AD07.61-P-4000-17A | ||
| P0460 | Fuel level gage sensor | Read out terminal | |
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0500 | A front left vehicle speed signal B rear left vehicle speed signal |
Check ASR in chassis diagnosis manual, index 9 AD42.45-P-1000AZ | |
| Vehicle speed signal, fault code description ME-SFI | AD07.61-P-4000-23A | ||
| P0507 | Idle speed control implausible | Signal 1 | AD07.61-P-6002-01A |
| Signal 2 | AD07.61-P-6002-01B | ||
| AD07.61-P-6002-03A | |||
| Idle speed control, fault code description ME-SFI | AD07.61-P-4000-24A | ||
| P0560 | Voltage supply to ME-SFI control module (N3/10) | AD07.61-P-6000-01A AD07.61-P-6000-02A |
|
| Control module voltage supply, fault code description ME-SFI | AD07.61-P-4000-59A | ||
| P0565 | Push-button switch for variable cruise control (S40/4) | AD07.61-P-6003-01D | |
| P0600 | CAN of ESP | AD07.61-P-6000-34A | |
| CAN damaged, fault code description ME-SFI | AD07.61-P-4000-26A | ||
| P0604 | A ME-SFI control module (N3/10) B ME-SFI control module (N3/10) |
N3/10 | |
| P0605 | ME-SFI control module (N3/10) | N3/10 |