Gasoline injection and ignition system (ME-SFI) - Diagnosis - Diagnostic trouble code memory - AD07.61-P-4000AA
ENGINES 112.910,
112.911 up to 31.5.00,
112.920,
112.921 up to 31.5.00,
112.923,
112.940 /941 /942 up to 31.5.00,
112.943
Fault codes from P0300 to P0699
| Hazard from contact with parts conducting high voltages. | Do not touch parts which conduct high voltages. Persons who wear electronic implants (e.g. heart pacemakers) must not carry out work on the ignition system. | AS15.10-Z-0001-01A | |
| Lethal hazard from being drawn into rotating vehicle parts | Do not reach into rotating parts. Wear closed and close-fitting work clothes. Secure area of rotating vehicle components against unauthorized access. |
AS00.00-Z-0004-01A | |
| Risk of explosion from fuel igniting, risk of poisoning from inhaling and swallowing fuel as well as risk of injury to eyes and skin from contact with fuel. | No fire, sparks, naked flames or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel. |
AS47.00-Z-0001-01A | |
| Notes on avoiding damage to the ignition system | Engines 104, 111, 112, 113, 119, 120 with ME-SFI fuel injection and ignition system | AH15.10-P-0002-01D | |
| The fault code cannot be read out with the pulse counter | |||
| ■ Symbol for USA vehicles for activation of the malfunction indicator lamp CHECK ENGINE • Symbol for EURO3 vehicles for activation of the engine diagnosis malfunction indicator lamp (is indicated in the HHT as ■) The malfunction indicator lamp does not go on until a fault relevant for the exhaust system was stored during the last driving cycle (exception misfire "damaging to TWC", malfunction indicator lamp goes on immediately). |
|||
| Ignition: On | |||
| Connect hand-held-tester (HHT), read out diagnostic trouble code memory | AD00.00-P-2000-03A | ||
| Gasoline injection and ignition system (ME-SFI) - diagnosis - previous knowledge | AD07.61-P-2000A | ||
| Check and adjust engine | Engine diagnosis manual | ||
| Diagnostic trouble code memory | |||
| Fault code |
Possible cause | Note | Remedy |
| No fault code | No fault detected | Depending on the complaint, carry out testing of ME-SFI electrical system in full | AD07.61-P-6000A |
| AD07.61-P-6001A | |||
| 112.942 in MODEL 163.154 up to 31.5.98 | AD07.61-P-6002A | ||
| AD07.61-P-6003A | |||
| AD07.61-P-6004C | |||
| P0300 ■ • | A Misfire | AD07.61-P-6001-11A | |
| B Misfire "damaging to TWC" | AD07.61-P-6001-12A | ||
| AD07.61-P-6001-13A | |||
| AD07.61-P-6001-14A | |||
| AD07.61-P-6001-15A | |||
| AD07.61-P-6001-16A | |||
| AD07.61-P-6001-17A | |||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11A | ||
| P0301 ■ • | A Misfire in cylinder 1 | AD07.61-P-6001-11A | |
| B Misfire in cylinder 1 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0302 ■ • | A Misfire in cylinder 2 | AD07.61-P-6001-12A | |
| B Misfire in cylinder 2 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0303 ■ • | A Misfire in cylinder 3 | AD07.61-P-6001-13A | |
| B Misfire in cylinder 3 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0304 ■ • | A Misfire in cylinder 4 | AD07.61-P-6001-14A | |
| B Misfire in cylinder 4 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0305 ■ • | A Misfire in cylinder 5 | AD07.61-P-6001-15A | |
| B Misfire in cylinder 5 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0306 ■ • | A Misfire in cylinder 6 | AD07.61-P-6001-16A | |
| B Misfire in cylinder 6 "damaging to TWC" | AD07.61-P-6001-17A | ||
| AD07.61-P-7002-01A | |||
| AD07.61-P-7002-01B | |||
| Compression pressure | |||
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0325 | Knock sensor on right | Connector line | |
| Knock sensor | |||
| Knock sensor, fault code description ME-SFI | AD07.61-P-4000-12A | ||
| P0330 | Knock sensor on left | Connector line | |
| Knock sensor | |||
| Knock sensor, fault code description ME-SFI | AD07.61-P-4000-12A | ||
| P0335 ■ • | Crankshaft position sensor (L5) | AD07.61-P-6001-09A | |
| Crankshaft position sensor, fault code description ME-SFI | AD07.61-P-4000-13A | ||
| P0341 ■ • | Camshaft Hall sensor (B6/1) | AD07.61-P-6001-10A | |
| Camshaft Hall sensor, fault code description ME-SFI | AD07.61-P-4000-14A | ||
| P0370 | Angle deviation for camshaft to crankshaft | Check basic adjustment of camshafts | |
| P0400 ■ | Exhaust gas recirculation malfunction (causal chain) | AD07.61-P-6000-27A | |
| Exhaust gas recirculation malfunction (causal chain), fault code description ME-SFI | AD07.61-P-4000-50A | ||
| P0410 ■ • | Secondary air injection malfunction (causal chain) | AD07.61-P-6000-24A | |
| AD07.61-P-6000-25A | |||
| AD07.61-P-6000-26A | |||
| Secondary air injection malfunction (causal chain), fault code description ME-SFI | AD07.61-P-4000-15A | ||
| P0422 ■ • | Effect of right three-way catalytic converter too low | Right three-way catalytic converter | |
| Three-way catalytic converter effect too low, fault code description ME-SFI | AD07.61-P-4000-16A | ||
| P0432 ■ • | Effect of left three-way catalytic converter too low | Left three-way catalytic converter | |
| Three-way catalytic converter effect too low, fault code description ME-SFI | AD07.61-P-4000-16A | ||
| P0440 ■ | Purge system leak (causal chain) | AD07.61-P-6000-30A | |
| AD07.61-P-6000-31A | |||
| Purge system leak (causal chain), fault code description ME-SFI | AD07.61-P-4000-17A | ||
| P0441 ■ | Purge control valve (Y58/1) Function | AD07.61-P-6000-29A | |
| AD07.61-P-6000-30A | |||
| Purge system leak (causal chain), fault code description ME-SFI | AD07.61-P-4000-17A | ||
| P0442 ■ | Purge system slight leak | AD07.61-P-6000-31A | |
| Purge system leak (causal chain), fault code description ME-SFI | AD07.61-P-4000-17A | ||
| P0443 ■ • | Purge control valve (Y58/1) | AD07.61-P-6000-29A | |
| Purge control valve, fault code description ME-SFI | AD07.61-P-4000-19A | ||
| P0446 ■ | A Activated charcoal canister shutoff valve (causal chain) | AD07.61-P-6000-32A | |
| B Shutoff valve for activated charcoal canister (Y58/4) | AD07.61-P-6000-33A | ||
| Activated charcoal canister shutoff valve, fault code description ME-SFI | AD07.61-P-4000-20A | ||
| P0450 ■ | A Tank pressure sensor (B4/3) electrical fault B Tank pressure sensor (B4/3), signal oscillates |
AD07.61-P-6000-33A Activated charcoal canister blocked |
|
| Tank pressure sensor, fault code description ME-SFI | AD07.61-P-4000-21A | ||
| P0455 ■ | Purge system with severe leak or voltage supply for tank pressure sensor (B4/3) | AD07.61-P-6000-31A AD07.61-P-6000-33A |
|
| Purge system leak (causal chain), fault code description ME-SFI | AD07.61-P-4000-17A | ||
| P0460 | Fuel level gage sensor | Read out terminal | |
| Misfires, fault code description ME-SFI | AD07.61-P-4000-11A | ||
| P0500 | A front left vehicle speed signal B rear left vehicle speed signal |
Check ASR in chassis diagnosis manual, index 9 AD42.45-P-1000AZ | |
| Vehicle speed signal, fault code description ME-SFI | AD07.61-P-4000-23A | ||
| P0507 | Idle speed control implausible | Signal 1 | AD07.61-P-6002-01A |
| Signal 2 | AD07.61-P-6002-01B | ||
| AD07.61-P-6002-03A | |||
| Idle speed control, fault code description ME-SFI | AD07.61-P-4000-24A | ||
| P0560 | Voltage supply to ME-SFI control module (N3/10) | AD07.61-P-6000-01A AD07.61-P-6000-02A |
|
| Control module voltage supply, fault code description ME-SFI | AD07.61-P-4000-59A | ||
| P0565 | Pushbutton switch for variable cruise control (S40/4) | AD07.61-P-6003-01D | |
| P0600 | CAN of ESP | AD07.61-P-6000-34A | |
| CAN damaged, fault code description ME-SFI | AD07.61-P-4000-26A | ||
| P0604 | A ME-SFI control module (N3/10) B ME-SFI control module (N3/10) |
N3/10 | |
| P0605 | ME-SFI control module (N3/10) | N3/10 |