LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (On-Board Diagnostic - Connectivity Master Unit) >> Diagnostic Assist Function [Connectivity Master Unit] >> Diagnostic Assist Code "90" Radio Reception Condition Inspection

Diagnostic Assist Code "90" Radio Reception Condition Inspection

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tune in the radio.
  2. Input diagnostic assist code "90" according to the diagnostic assist code input procedure. (See DIAGNOSTIC ASSIST CODE INPUT PROCEDURE .)
  3. Inspect the malfunctioning location according to the following table:
    CAUTION:
    • Even if the system is normal, radio reception may be difficult depending on where the system is inspected (indoors/outdoors, or conditions at the location). Before inspecting the system, verify that radio reception is adequate.
    • When performing the inspection, select a frequency (radio station) with optimum reception in the area.
    Inspection Display of center display (Diagnostic result) Action
    • Start the radio reception condition inspection mode.
    • Select frequency (radio station) by operating the commander knob.
    • Verify the inspection result.
    TAU AM Reception Level Test Result:10-5 Radio reception condition is normal 
    • Center roof antenna, antenna feeder, and tuner and amp unit (TAU) are normal.
    TAU AM Reception Level Test Result:4-3 Radio reception condition is unstable 
    • Change frequencies and re-perform the inspection.
    TAU AM Reception Level Test Result:2-0 Inspect the center roof antenna and antenna feeder.
    (See CENTER ROOF ANTENNA INSPECTION .)
    (See ANTENNA FEEDER NO. 1 INSPECTION .)
    (See ANTENNA FEEDER NO. 2 INSPECTION .)
    (See ANTENNA FEEDER NO. 3 INSPECTION .)
  4. Cancel the diagnostic assist function according to the ending procedure. (See ENDING PROCEDURE .)