LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 597 (Exterior Trim) >> Door Sash Film Removal

Door Sash Film Removal

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Partially peel back the glass run channel.
  2. Partially peel back the door weatherstrip.
  3. Remove the following parts:
    1. Inner garnish. See INNER GARNISH REMOVAL/INSTALLATION .
    2. Front door trim. See. FRONT DOOR TRIM REMOVAL/INSTALLATION .
    3. Power outer mirror. See. POWER OUTER MIRROR REMOVAL/INSTALLATION .
    4. Rear door trim. See. REAR DOOR TRIM REMOVAL/INSTALLATION .
    5. Rear door speaker. See. REAR DOOR SPEAKER REMOVAL/INSTALLATION .
    6. Rear door quarter glass. See. REAR DOOR QUARTER GLASS REMOVAL/INSTALLATION .
    7. Rear sash molding. See. REAR DOOR TRIM REMOVAL/INSTALLATION .
    8. Front sash molding. See. FRONT SASH MOLDING REMOVAL .
    9. Front beltline molding. See. FRONT BELTLINE MOLDING REMOVAL/INSTALLATION .
    10. Rear beltline molding. See. REAR BELTLINE MOLDING REMOVAL/INSTALLATION .
  4. Peel off the rear sash film by pulling it outward from one end.
    NOTE:
    • Slowly remove the door sash film since it may tear easily.
    Fig 1: View Of Door Sash Film Removal
    G04861203Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals