948TE/9HP48 - DTCS P0219-00 To P0885-00

• DTC Troubleshooting
  • P0219-00-Engine OVERSPEED Condition
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0562-00-System Voltage Low
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0563-00-System Voltage High
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0601-00-Internal Control Module Memory Checksum Error
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0610-00-Ecu Vehicle Options Mismatch
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0613-00-Internal Transmission Processor
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P061B-00-Internal Control Module Torque Calculation Performance
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P062F-00-Internal Control Module EEPROM Error
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0631-00-VIN Not Programmed Or Incompatible TCM
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0634-00-Pcm-ECM-TCM Internal Temperature Too High
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0643-00-Sensor Reference Voltage 1 Circuit High
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P064F-00-Unauthorized Software-Calibration Detected
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0653-00-Sensor Reference Voltage 2 Circuit High
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0701-00-Transmission Control System Performance
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0703-00-Brake Switch 2 Performance
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0706-00-Transmission Range Sensor Performance
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • P0707-00-Transmission Range Sensor A Circuit Low
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • P0708-00-Transmission Range Sensor "A" Circuit High
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Possible Causes
    • Diagnostic Test
  • P0711-00-Transmission Fluid Temperature Sensor "A" Circuit Range/Performance
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0712-00-Transmission Fluid Temperature Sensor "A" Circuit Low
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0713-00-Transmission Fluid Temperature Sensor "A" Circuit High
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0716-00-Input Shaft Speed Sensor 1 Performance
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0721-00-Output Shaft Speed Sensor Circuit Performance
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0729-00-Gear 6 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P072F-00-Stuck In Gear 4
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0731-00-Gear 1 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0732-00-Gear 2 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0733-00-Gear 3 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0734-00-Gear 4 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0735-00-Gear 5 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P073E-00-Unable To Engage Reverse
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P076F-00-Gear 7 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P077C-00-Output Shaft Speed Sensor Circuit Low
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P077D-00-Output Shaft Speed Sensor Circuit High
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P077E-00-Transmission Fluid Temperature Multiple Sensor Correlation
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P079A-00-Transmission Friction Element 1 Slip Detected
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P07BF-00-Input/Turbine Shaft Speed Sensor 1 Circuit Low
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P07C0-00-Input/Turbine Shaft Speed Sensor 1 Circuit High
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P07D9-00-Gear 8 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P07F6-00-Gear 9 Shift Incorrect Ratio
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0810-00-Clutch Position Control Error
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0850-00-Park/Neutral Switch Performance
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0885-00-TCM Power Control Circuit
    • Notes
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test