Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read all DTCs and record on the repair order.
2. Record the Event Data and Environmental Data.
3. With the scan tool, erase DTCs.
4. Using the recorded Event and Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. With the scan tool, read TCM DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK TRANSMISSION FLUID LEVEL
1. Check the Transmission Fluid level. Refer to FLUID AND FILTER, STANDARD PROCEDURE .
2. Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
3. With the scan tool, read TCM DTCs.
  Did the DTC return?
  
  Yes
  - Go To 3
  No
  - Test Complete.
REPLACE THE VALVE BODY AND CHECK FOR PROPER OPERATION
1. Replace the Valve Body in accordance with the Service Information. Refer to VALVE BODY, REMOVAL .
2. Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
3. With the scan tool, read TCM DTCs.
  Did the DTC return?
  
  Yes
  - Replace the Transmission in accordance with the Service Information. Refer to REMOVAL .
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
  No
  - Test Complete.