Section 5 (Engine Mechanical - 2.7L (L3B) - Specifications)
WARNING: This page is about a different variant/trim than selected.
- Specifications
- Fastener Specifications
- Bolt Sequence And Torque Specifications
- Automatic Transmission Flex Plate Bolt Sequence
- Balancer Shaft Housing Bolt Sequence
- Camshaft Bearing Cap Bolt Sequence
- Camshaft Carrier Bolt Sequence
- Compressor Air Turbocharger Bolt Sequence
- Crankshaft Bearing Cap Bolt Sequence
- Crankshaft Rear Oil Seal Housing Bolt Sequence
- Cylinder Head Bolt Sequence
- Engine Front Cover Bolt Bolt Sequence
- Intake Manifold Bolt Sequence
- Lower Crankcase Extension Bolt Sequence - AWD
- Lower Crankcase Extension Bolt Sequence - RWD
- Lower Oil Pan Bolt Sequence - AWD
- Lower Oil Pan Bolt Sequence - RWD
- Positive Crankcase Ventilation Oil Separator Bolt Sequence
- Positive Crankcase Ventilation Oil Separator Cover Bolt Sequence
- Positive Crankcase Ventilation Baffle Bolt Sequence
- Timing Chain Upper Cover Bolt Sequence
- Approximate Fluid Capacities
- Engine Mechanical Specifications
- Crankshaft Bearing Selection Specifications
- Adhesives, Fluids, Lubricants, and Sealers