Crankshaft Bearing Cap Bolt Sequence
WARNING: This page is about a different variant/trim than selected.
| Crankshaft Bearing Cap Bolt Sequence | |||||
|---|---|---|---|---|---|
| Callout | Component Name [Component Quantity] | Single Use Fastener/Component | Thread Locking Adhesive Required | Specification | Procedure |
| Metric (English) | |||||
| 1 | Crankshaft Bearing Cap Bolt [10x] | - | - | First Pass: 20 N.m (15 lb ft) Final Pass: 120 degrees |
CRANKSHAFT AND BEARING REMOVAL AND INSTALLATION (AWD) or CRANKSHAFT AND BEARING REMOVAL AND INSTALLATION (RWD) |