Camshaft Bearing Cap Bolt Sequence
WARNING: This page is about a different variant/trim than selected.
| Camshaft Bearing Cap Bolt Sequence | |||||
|---|---|---|---|---|---|
| Callout | Component Name [Component Quantity] | Single Use Fastener/Component | Thread Locking Adhesive Required | Specification | Procedure |
| Metric (English) | |||||
| 1 | Camshaft Bearing Cap Bolt [26x] | - | - | First Pass: 8 N.m (71 lb in) Second Pass: Loosen 60 degrees Final Pass: 15 N.m (11 lb ft) |
Exhaust Camshaft Replacement , or Intake Camshaft Replacement |