Section 14 (Engine Mechanical - 4.6L (LH2) - Repair Instructions - Off Vehicle - 1 Of 3)

• Engine Wiring Harness Assembly Removal
  • Left Side Harness Connections
  • Right Side Harness Connections
• Exhaust Manifold Removal - Left Side
• Exhaust Manifold Removal - Right Side (RWD)
• Exhaust Manifold Removal - Right Side (AWD)
• Drive Belt Removal
  • Outer Drive Belt
  • Inner Drive Belt
• Power Steering Pump Removal
  • Tools Required
• Drive Belt Idler Pulley Removal
• Generator Removal
• Air Conditioning (A/C) Compressor Removal
• Drive Belt Tensioner Removal
  • Generator Drive Belt Tensioner
  • P/S Pump and A/C Compressor Drive Belt Tensioner
• Water Outlet Housing Removal
• Intake Manifold Removal
• Starter Removal
• Crankshaft Balancer Removal
• Engine Flywheel Removal
  • Tools Required
• Crankshaft Rear Oil Seal Removal
• Oil Level Indicator and Tube Removal
• Oil Filter Adapter Removal (Without Oil Cooler)
• Oil Filter Adapter Removal (With Oil Cooler)
• Ignition Coil Module Removal - Left Side
• Camshaft Cover Removal - Left Side
• Camshaft Position Actuator Housing Removal - Left Side
• Ignition Coil Module Removal - Right Side
• Camshaft Cover Removal - Right Side
• Camshaft Position Actuator Housing Removal - Right Side
• Engine Front Cover Removal
• Oil Pump Removal
• Secondary Camshaft Intermediate Drive Chain Removal - Right Side
• Secondary Camshaft Intermediate Drive Chain Removal - Left Side
• Oil Pump Outlet Tube Removal
• Primary Camshaft Intermediate Drive Chain Removal
• Camshaft Intermediate Drive Shaft Removal
• Exhaust Camshaft Removal - Left Side
• Intake Camshaft Removal - Left Side
• Valve Rocker Arm Removal - Left Side
• Valve Lifter Removal - Left Side
• Cylinder Head Removal - Left Side
• Exhaust Camshaft Removal - Right Side
• Intake Camshaft Removal - Right Side
• Valve Rocker Arm Removal - Right Side
• Valve Lifter Removal - Right Side
• Cylinder Head Removal - Right Side
• Oil Pan Removal
• Oil Pump Suction Pipe and Screen Assembly Removal
• Lower Crankcase Removal
• Piston, Connecting Rod, and Bearing Removal
• Crankshaft and Bearing Removal
  • Crankshaft Removal Procedure
  • Crankshaft Bearing Removal Procedure
• Engine Block Disassemble - Upper
• Engine Block Cleaning and Inspection - Upper
  • Special Tools
  • Cleaning Procedure
  • Visual Inspection
  • Cylinder Bore Diameter Measurement Procedure
  • Deck Face Flatness Measurement Procedure
  • Cylinder Bore Taper Measurement Procedure
  • Cylinder Bore Out-of-Round Measurement Procedure
• Engine Block Assemble - Upper